New Brunswick Craft Brewers Association
Brewing => Equipment => Topic started by: Kyle on April 22, 2011, 04:03:47 PM
-
In general, aluminum pots are great, lightweight, and cheaper than stainless steel. The link to Alzheimer’s has been dismissed as bogus in current medical thought.
However, as I was using my new weldless ball-valve and hop strainer, I noticed that the pot was flexing when using the tap.
So, I have to say, that AL pots might not be good if you are going to be putting fittings in them.
Otherwise, they work very well though
-
whaa? flexing? how thin is your alu pot?
and +1 on the Alzheimers link being bullshit.
-
Actually, it turned out that by tightening the bulkhead, most of the flexing ceased, but there is still a bit. The pot is very thin, probably about 2/3 that of a dime.
-
Ok mine is about 5x that I think. I didn't think they made them that thin.